TM 9-2320-260-34-1
3-71. FRONT GEAR COVER INSTALLATION
THIS TASK COVERS:
Installation
INITIAL SETUP
MATERIALS/PARTS
APPLICABI.E MODELS
Two lockwashers (Appendix D, Item 215)
All
TOOLS
Shims (Appendix D, Item 500)
General mechanic's tool kit
Gasket (Appendix D, Item 58)
(Appendix B, Item 1)
REFERENCES (TM)
Feeler gage (Appendix B, Item 58)
TM 9-2320-260-20
TM 9-2320-260-34P-1
Screws securing front gear case cover are different lengths. Ensure
screws are installed in their proper places. Failure to do so may
result in damage to equipment.
Installation
1.
Install new gasket (1) and front gear cover (6) on cylinder block (2) with fifteen screws (7), two
2.
Remove two screws (15), camshaft cover (14), spacer (11), and shim(s) (12) from front gear cover (6).
Place camshaft cover (14) against camshaft (13) and measure clearance between cover (14) and front
3.
gear cover (6) with feeler gage.
4.
Measure shim(s) (12) as a pack with micrometer. Add or subtract shim(s) (12) from pack to provide
a clearance of 0.001-0.005 in. (0.0254-0.127 mm) for engines with camshaft thrust plate or
0.008-0.013 in. (0.2032-0.3302 mm) for engines with camshaft outboard bearing support.
Install camshaft cover (14), spacer (11), and shim(s) (12) on front gear cover (6) with two
5.
screws (15).
6.
Remove dowel pins (refer to para, 3-33) from cylinder block (2).