TM 9-2320-260-34-1
3-24. ENGINE AND TRANSMISSION REPLACEMENT (Contd)
GENERAL SAFETY INSTRUCTIONS
GENERAL SAFETY INSTRUCTIONS (Contd)
All personnel must stand clear during lifting
Diesel fuel is flammable. Do not perform this task
operations.
near open flame.
Use tanker or breaker bar to free engine
Do not disconnect air lines before draining air
during lifting operations.
reservoirs.
Do not detach chain from engine until all
Lifting device must have a weight capacity greater
engine weight is evenly distributed and
than the engine and transmission.
engine is stable on transport stand.
a. Preliminary Disconnections
CAUTION
Do not operate alternator with output terminal (POS) discon-
nected or damage to alternator will result.
NOTE
Tag all wires for installation.
1.
Remove two screws (2) and lockwashers (3) from terminal cover (1) and alternator (4). Discard
lockwashers (3).
2.
Pry terminal cover (1) away from adhesive sealant and remove sealant from alternator (4).
3.
Remove two screws (11), lockwashers (10), retaining strap (12), and spacer plate (13) from positive
wire (14), lead (5), and alternator (4). Discard lockwashers (10).
4.
Remove screw (9), lockwasher (8), and ground wire (7) from alternator (4). Discard lockwasher (8).
5.
Disconnect lead (5) from wire (6).
6.
Remove nut (16), lockwasher (15), and positive wire (14) from alternator (4). Discard lockwasher (15).
NOTE
Perform step 7 for late model vehicles.
Loosen two clamps (17) and remove breather tube (20) from breather (18) and elbow (19).
7.
3-77
