TM 9-2320-260-34-1
3-19. CAM FOLLOWER HOUSING MAINTENANCE (Contd)
f. Installation
CAUTION
Ensure cam follower housing levers have been lubricated before
installation.
If old cam follower housing assemblies are being installed,
ensure they are installed in the same location from which they
were removed.
NOTE
Check measurement of gasket previously removed. Thickness
must be the same as original gasket in the range of 0.014-0.125 in.
(0.36-3.2 mm).
1.
Measure new gasket (3) thickness.
Position gasket (3) on cylinder block (1) with sealing surface facing outward.
2.
Install cam follower housing (4) on cylinder block (1). Tap with soft-head hammer to seat on
3.
dowels (2).
Install five new screw-assembled lockwashers (5) on cam follower housing (4). Finger tighten screw-
4.
assembled lockwashers (5).
Install clamp (7) on cam follower housing (4) with new screw-assembled lockwasher (6). Tighten
5.
screw-assembled lockwashers (5) and (6) 15 lb-ft (20 Nm) in sequence shown.
Tighten screw-assembled lockwashers (5) and (6) 30-35 lb-ft (41-48 Nm) in sequence shown.
6.
3-58
