TM 9-2320-260-20
Section X. CONVOY WARNING LIGHT KIT MAINTENANCE
14-50. CONVOY WARNING LIGHT KIT MAINTENANCE INDEX
PARA.
PAGE
TITLE
NO.
NO.
Convoy Warning Light Mount Replacement
Convoy Warning Light Mount (M820, M820A1, M820A2) Replacement
Convoy Warning Light Mount (M817) Replacement
Convoy Warning Light Harness Replacement
Convoy Warning Light Harness (M817) Replacement
Convoy Warning Light Harness (M820, M820A1, M820A2) Replacement
Convoy Warning Light Resistor and Leads Replacement
Convoy Warning Light Replacement
Convoy Warning Light Switch Replacement
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All (except M817, M820, M820A1, M820A2)
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Nine locknuts
Screw-assembled lockwasher
Parking brake set (TM 9-2320-260-10).
Convoy warning light removed (para. 14-58).
NOTE
The left and right convoy warning light mounts are replaced the
same way. This procedure covers the left light mount only.
1. Disconnect two leads (13) from connectors (14).
2. Remove screw-assembled lockwasher (12), washer (11), clamp (10), and cable (22) from gun mount
bracket (9). Discard screw-assembled lockwasher (12).
3. Remove cable (22) from mounting plate (1) and support tube (2).
4. Remove wing screw (20), pin (21), and support tube (2) from bracket tube (16) and bracket (19).
5. Remove two locknuts (18), washers (17), U-bolt (6), locknut (5), washer (4), screw (3), and
bracket (19) from bracket tube (16). Discard locknuts (5) and (18).
14-96
