TM 9-2320-260-20
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
M817
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Thirty locknuts
Lockwasher
Parking brake set (TM 9-2320-260-10).
Two tiedown straps (Appendix C, Item 33)
NOTE
Tag all wires for installation.
1.
Disconnect two leads (7) from two leads (8) on two convoy warning lights (6).
2.
Remove eighteen locknuts (5), screws (2), clamps (3), and harness (9) from upper cab protector (4).
Discard locknuts (5).
Remove ten locknuts (12), screws (10), clamps (11), and harness (9) from dump body (1) and left
3.
front of cab protector (4). Discard locknuts (12).
Disconnect lead (22) from cable (20).
4.
5.
Remove locknut (23), washer (24), ground lead (28), lockwasher (25), screw (27), and washer (26)
from crossmember (21). Discard lockwasher (25) and locknut (23).
6.
Remove locknut (16), screw (30), clamp (14), and harness (9) from crossmember (17). Discard
locknut (16).
Remove screw (13), clamp (15), and harness (9) from frame (18).
7.
Remove two tiedown straps (19) from harness (9). Discard tiedown straps (19).
8.
9.
Remove harness (9) from front of cab protector (4) and dump body (1).
10.
Remove conduit (29) from harness (9).
1.
Install conduit (29) on harness (9).
2.
Connect two leads (8) to two leads (7) on two convoy warning lights (6).
3.
Route harness (9) along inside of upper cab protector (4) and install with eighteen clamps (3),
screws (2), and new locknuts (5).
4.
Route harness (9) along left front of cab protector (4) and insert through dump body (1).
Install harness (9) on cab protector (4) with ten clamps (11), screws (10), and new locknuts (12).
5.
6.
Route harness (9) to rear of dump body (1) through corrugation of floor (31).
7.
Connect lead (22) to cable (20).
Install ground lead (28) on crossmember (21) with washer (26), screw (27), new lockwasher (25),
8.
washer (26), and new locknut (23).
Pull harness (9) tight and install on frame (18) with clamp (15) and screw (13).
9.
10.
Install harness (9) on crossmember (17) with clamp (14), screw (30), and new locknut (16).
Take up harness (9) slack by looping and securing with two new tiedown straps (19).
11.
14-106
