TM 9-2320-260-20
13-55. POWER DIVIDER CONTROL LEVER AND LINKAGE REPLACEMENT (Contd)
Remove cotter pin (12), clevis pin (23), and clevis end (13) from power divider arm (10). Discard
1.
cotter pin (12).
2.
Remove cotter pin (15), clevis pin (25), and rod (14) from lever (16). Discard cotter pin (15).
3.
Remove cotter pin (18), clevis pin (6), and clevis end (5) from lever (7). Discard cotter pin ( 18).
4.
Remove cotter pin (1), clevis pin (3), and rod (2) from lever (17). Discard cotter pin (1).
5.
Remove two locknuts (11), screws (22), and bracket (20) from crossmember (9). Discard
locknuts (11).
6.
Remove two pins (8) and levers (7) and (16) from shaft (21).
7.
Remove shaft (21) and grease fitting (19) from bracket (20).
8.
Loosen jamnut (4) and remove clevis end (5) and jamnut (4) from rod (2).
9.
Loosen jamnut (24) and remove clevis end (13) and jam nut (24) from rod (14).
10.
Bend four tabs (41) up and remove boot (26) from floor (36).
11.
Remove four locknuts (37), screws (38), and two brackets (35) from floor (36). Discard locknuts (37).
12.
Remove locknut (27), screw (39), and lever (17) from shaft (29). Discard locknut (27).
13.
Remove woodruff key (28) and two brackets (35) from shaft (29). Discard woodruff key (28).
14.
Remove locknut (34), washer (33), spring (32), and lock (30) from lever (31). Discard locknut (34).
15.
Remove two grease fittings (40) from brackets (35).
1.
Install two grease fittings (40) on brackets (35).
2.
Install lock (30) and spring (32) on lever (31) with washer (33) and new locknut (34).
3.
Position two brackets (35) and new woodruff key (28) on shaft (29).
4.
Install lever (17) on shaft (29) with screw (39) and new locknut (28).
5.
Install two brackets (35) on floor (36) with four screws (38) and new locknuts (37).
6.
Install boot (26) on floor (36) and bend four tabs (41) down.
7.
Install jamnut (24) and clevis end (13) on rod (14).
8.
Install jamnut (4) and clevis end (5) on rod (2).
9.
Install grease fitting (19) on bracket (20).
10.
Position shaft (21) in bracket (20).
11.
Install two levers (7) and (16) on shaft (21) with two pins (8).
12.
Install bracket (20) on crossmember (9) with two screws (22) and new locknuts (11).
13.
Install rod (2) on lever (17) with clevis pin (3) and new cotter pin (1).
14.
Install clevis end (5) on lever (7) with clevis pin (6) and new cotter pin (18).
15.
Install rod (14) on lever (16) with clevis pin (25) and new cotter pin (15).
16.
Install clevis end (13) on power divider arm (10) with clevis pin (23) and new cotter pin (12).
13-124
