TM 9-2320-260-20
THIS TASK COVERS:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Inspection
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-10
M820A2
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Four lockwashers
Parking brake set (TM 9-2320-260-10).
Two cotter pins
Van liftgate safety latch removed (para. 13-48).
NOTE
The left and right side control levera are replaced the same way.
This procedure covers the left side only.
Remove two cotter pins (1), retaining pin (2), and control rod (4) from frame bracket (3). Discard cotter
pins (1).
1. Remove jamnut (5), nut (6), bracket (7), spring (8), nut (9), and jamnut (10) from
rod (11).
2. Remove lubrication fitting (12) from bracket (7).
3. Remove jamnut (19), nut (18), tubescrew (17), spring (16), nut (15), and jamnut (14) from rod (13).
1. Inspect rods (11) and (13) for cracks, breaks, and twists. Replace rod (11) or (13) if damaged.
2. Inspect springs (8) and (16) for distortion and warping. Replace spring (8) or (16) if damaged.
1. Install jamnut (14), nut (15), spring (16), tubescrew (17), nut (18), and jamnut (19) on rod (13).
2. Install grease fitting (12) on bracket (7).
3. Install jamnut (10), nut (9), spring (8), bracket (7), nut (6), and jamnut (5) on rod (11).
Install control rod (4) on frame bracket (3) with retaining pin (2) and two new cotter pins (1).
13-110
