TM 9-2320-260-20
I
13-48. VAN LIFTGATE SAFETY LATCH REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-260-10
M820A2
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Cotter pin
Parking brake set (TM 9-2320-260-10).
Liftgate lowered to ground level
(TM 9-2320-260-10).
The left and right latches are replaced the same way. This
procedure covers the left side only.
1. Remove cotter pin (3) from control lever (5). Discard cotter pin (3).
2. Remove two snaprings (4) from retaining pin (10).
3. Remove retaining pin (10) and two spacers (2) from safety latch (1).
4. Remove jamnut (8), nut (7), washer (6), and control lever (5) from angle linkage (9).
5. Remove safety latch (1) from control lever (5).
1. Position safety latch (1) on control lever (5).
2. Install control lever (5) on angle linkage (9) with washer (6), nut (7), and jamnut (8).
3. Install retaining pin (10) on safety latch (1) with two spacers (2) and snaprings (4).
4. Install new cotter pin (3) on control lever (5).
13-112
