TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
c. Adjustment
b. hstallation
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
M816
q Parking brake set (TM 9-2320-260-10).
q Throttle control lever removed (para. 13-40).
MATERIALS/PARTS
Two locknuts
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
1. Remove clevis yoke (4) and nuts (3) and (2) from cable (l).
2.
Remove cable (1) from bracket (5).
NOTE
Tag location of clamps before removing cable.
3. Remove locknut (10), washer (9), and cable clamp (8) from accelerator stop (7). Discard locknut (10).
4. Remove locknut (13), washer (12), screw (6), and cable clamp (14) from bracket (11). Discard
locknut (13).
5. Remove setscrew (17), collar (16), and cable (1) from cable linkage (15).
6. Remove cable clamps (8) and (14) from cable (1).
1. Position cable clamps (8) and (14) on cable (1).
2. Install cable (1) on cable linkage (15) with collar (16) and setscrew (17).
3. Install cable clamp (14) on bracket (11) with screw (6), washer (12), and new locknut (13). Do not
tighten locknut (13).
4. Install cable clamp (8) on accelerator stop (7) with washer (9) and new locknut (10). Do not tighten
locknut (10).
5. Install cable (1) on bracket (5) with nuts (2) and (3) and clevis yoke (4).
6. Tighten locknuts (10) and (13).
1. Remove locknuts (10) and (13) and washers (9) and (12) from cable clamps (8) and (14).
2. Position cable (1), as necessary, and secure with washers (9) and (12) and new locknuts (10) and
(13).
13-94
