TM 9-2320-260-20
I
THIS TASK COVERS:
c. Cab Door Glass Adjustment
a.. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Two fasteners
Lockwasher
Parking brake set (TM 9-2320-260-10).
q Cab door access cover removed (para. 11-12).
1.
Lower cab door glass (1) so regulator channels (3) are accessible through cab door (2).
NOTE
Mark position of regulator stop brackets for installation.
Remove screw (4), lockwasher (5), and window regulator bracket (6) from regulator channel (3).
2.
Discard lockwasher (5).
Remove two fasteners (8) from window regulator arm studs (7). Discard two fasteners (8).
3.
Pull two regulator arm studs (7) out of regulator channels (3) and remove cab door glass (1)
4.
from cab door (2).
Remove weatherseal (10) from cab door (2).
5.
Remove five clips (9) from weatherseal (10).
6.
1. Install five clips (9) on weatherseal (10) and aline clips (9) with panel slots (11).
2. Install weatherseal (10) and five clips (9) on cab door (2) so clips (9) snap into corresponding panel
slots (11).
3. Position cab door glass (1) in cab door (2) and install two window regulator arm studs (7) through
regulator channels (3).
4. Install two new fastenera (8) on window regulator arm studs (7).
5. Install window regulator bracket (6) on regulator channel (3) with new lockwaaher (5) and screw (4).
Do not tighten screw (4).
1. Raise cab door glass (1) to full up position.
NOTE
Ensure cab door glass meets glass seal at top with door in closed
position.
2. If glass does not seal at top, move glass up until it meets seal.
3. Lower cab door glass (1) and tighten screw (4).
11-34
