TM 9-2320-260-20
11-7. RIGHT SIDE PANEL MAINTENANCE
THIS TASK COVERS:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Three bumpers
. Parking brake set (TM 9-2320-260-10).
Seven lockwashers
Fifteen locknuts
. Hood raised and secured (TM 9-2320-260-10).
NOTE
Perform step 1 on vehicles equipped with personnel hot water
heater.
1. Remove clamp (7) and hose (6) from elbow (8).
2. Turn two thumb cranks ( 14) and (25) to unlock side panel (5) from fender (24).
3. Raise spring clip (19) and remove side panel (5) from fender (24) by sliding side panel (5) forward
until free of vehicle.
NOTE
Perform steps 1 and 2 on vehicles equipped with personnel hot
water heater.
1.
Remove three nuts (13), lockwashers (12), screws (23), and hood (22) from side panel (5). Discard
lockwashers (12).
2.
Remove four nuts (10), lockwashers (9), screws (21), screen ( 11), and elbow (8) from side panel (5).
Discard lockwashers (9).
Remove four locknuts (4), retainer (3), seal (2), and four screws (1) from side panel (5). Discard
3.
locknuts (4).
Remove four locknuts (16), screws (20), and two locks (15) from side panel (5). Discard locknuts (16).
4.
5.
Remove locknut (40), three screws (39) and (34), washers (38) and (35), bracket (36), and hinge (37)
from rear of fender (24). Discard locknut (40).
6.
Remove two locknuts (43), washers (42), hinge (41), and two screws (44) from front offender (24).
Discard locknuts (43).
7.
Remove two locknuts (28), washers (27), hinge pin (26), and two screws (29) from rear of side
panel (5). Discard locknuts (28).
8.
Remove two locknuts (31), washers (30), spring clip (19), hinge pin (32), and two screws (33) from
front of side panel (5). Discard locknuts (31).
9.
Remove three bumpers (18) from headlight bracket (17). Discard bumpers (18).
11-10
