TM 9-2320-260-20
1. Install three new bumpers (18) on headlight bracket (17).
2. Install hinge pin (32) and spring clip (19) on front of side panel (5) with two screws (33),
washers (30), and new locknuts (31).
3. Install hinge pin (26) on rear of side panel (5) with two screws (29), washers (27), and new
locknuts (28).
4. Install hinge (41) on front offender (24) with two screws (44), washers (42), and new locknuts (43).
5. Install hinge (37) and bracket (36) on rear offender (24) with three screws (39) and (34), washers
(38) and (35), and new locknut (40).
6. Install two locks (15) on side panel (5) with four screws (20) and new locknuts (16).
7. Install seal (2) and retainer (3) on side panel (5) with four screws (1) and new locknuts (4).
NOTE
Perform steps 8 and 9 on vehicles equipped with personnel hot
water heater.
8. Install screen (11) and elbow (8) on side panel (5) with four screws (21), new lockwashers (9),
and nuts (10).
9. Install hood (22) on side panel (5) with three screws (23), new lockwashers (12), and nuts (13).
1. Aline two hinge pins (32) and (26) with two hinges (41) and (37), raise spring clip (19) and install
side panel (5) on fender (24) by sliding side panel (5) to the rear until in place.
2. Lock side panel (5) to fender (24) by turning two thumb cranks (14) and (25).
NOTE
Perform step 3 on vehicles equipped with personnel hot water
heater.
3. Install hose (6) on elbow (8) with clamp (7).
11-12
