TM 9-2320-260-20
I
THIS TASK COVERS:
a. Hood Holddown Fastener and Bracket Removal d. Hood Support Hook Installation
b. Safety Latch Removal
e. Safety Latch Installation
c. Hood Support Hook Removal
f. Hood Holddown Fastener and Brackets Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
TM 9-2320-260-20P
MATERIALS/PARTS
EQUIPMENT CONDITION
Twelve locknuts
Parking brake set (TM 9-2320-260-10).
I
I
a Hood Holddown Fastener and Bracket Removal
1. Unlatch two fasteners (16) from brackets (15).
2. Raise and secure hood (8) (TM 9-2320-260-10).
3. Remove four locknuts (11), screws (17), and two fasteners (16) from brushguard (19). Discard
locknuts (11).
4. Remove four locknuts (12), washers (13), and two brackets (15) from hood (8). Discard locknuts (12).
5. Remove four nuts (14) from two brackets (15).
Remove two locknuts (9), screws (18), and safety latch (10) from hood (8). Discard locknuts (9).
1. Lower hood (8).
2. Remove hook (5) from clip (7).
3. Remove screw (6) and clip (7) from cowling (20).
4. Remove locknut (1), washer (2), nut (4), and hook (5) from bolt (3). Discard locknut (1).
5. Remove glove compartment (para. 11-33).
NOTE
Assistant will help with step 6.
6. Remove locknut (21) and bolt (3) from cowling (20), Discard locknut (21).
I
d. Hood Support Hook Installation
NOTE
Assistant will help with step 1.
1. Install nut (4), bolt (3), washer (2), and new locknut (1) on hook (5). Install assembled hook (5)
on cowling (20) with new locknut (21).
2. Install glove compartment (para. 11-33).
3. Install clip (7) on cowling (20) with screw (6).
4. Install hook (5) on clip (7).
11-4
