TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
b. Installation
lNITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE MODELS
Parking brake set (TM 9-2320-260-10).
All
Access panel removed (TM 9-2320-260-10).
MATERIALS/PARTS
Steering gear shield removed (para. 11-25).
Two lockwashers
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
NOTE
Mark position of shaft for installation.
1. Scribe a mark through the slots of the universal joints (3) and (7) to the steering gear (1) and
steering column (6).
2. Remove two nuts (4), lockwashers (5), and screws (2) from universal joints (3) and (7), steering
gear (1), and steering column (6). Discard lockwashers (5).
3. Slide shaft (8) toward steering column (6) and remove from steering gear (1).
4. Remove shaft (8) from steering column (6).
b. Installation
1. Aline mark on universal joint (7) with mark on steering column (6) and install shaft (8) on steering
column (6).
2. Aline mark on universal joint (3) with mark on steering gear (1) and install shaft (8) on steering
gear (1).
3. Install two screws (2), new lockwashers (5), and nuts (4) on universal joints (3) and (7), steering
gear (1), and steering column (6). Tighten nuts (4) 35 lb-ft (47 Nm).
9-36
