TM 9-2320-260-20
I
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE MODELS
All
Parking brake set (TM 9-2320-260-10).
q Horn button removed (para. 4-30).
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
a. Removal
1.
Place wheels in straight-ahead position.
2. Loosen screw (6) and slide turn signal control (8) down steering column (7).
NOTE
Perform step 3 only if vehicle is equipped with airbrake hand
control lever.
3. Loosen two screws (5) and slide airbrake hand control lever (4) down steering column (7).
4. Unscrew nut (2) until it is level with top of shaft (3).
5. Install adapter (11) on steering wheel shaft (3) and adapter (12) on steering column (7).
6. Install puller (10) on adapters (11) and (12) and tighten puller screw (9) until steering wheel (1)
pops loose.
7. Remove puller (10), nut (2), adapters (11) and (12), and steering wheel (1) from steering
column (7).
1.
Place steering wheel (1) with adapter (11) and (12) on steering column (7) and tap evenly on
wheel (1) until nut (2) can be installed.
2.
Install nut (2) on steering wheel shaft (3). Tighten nut (2) 55-60 lb-ft (75-81 Nm).
NOTE
Perform step 3 only if vehicle is equipped with airbrake hand
control lever.
3. Slide airbrake hand control lever (4) up steering column (7) and tighten two screws (5).
4. Slide turn signal control (8) up steering column (7) and tighten screw (6).
9-34
