TM 9-2320-260-20
6-4. TRANSFER CASE SHIFT LEVER AND CONTROL LINKAGE MAINTENANCE (Contd)
c. Adjustment
1.
Position tunnel cover (9) on cab floor (8).
2.
Shift transfer control lever (1) to high and low range positions (TM 9-2320-260-10).
3.
If control lever (1) hits rear tunnel cover (9) when shifting transfer case to low range, shorten
adjusting rod (7). Remove tunnel cover (9) from cab floor (8). Back off jamnut (2) from yoke (4),
Remove cotter pin (5) and clevis pin (3) from yoke (4) and relay lever (6). Turn yoke (4) clockwise
to shorten adjusting rod (7). Install adjusting rod (7) on relay lever (6) with clevis pin (3) and cotter
pin (5). Check for correct free travel of transfer control lever (1) in high and low range.
4.
If control lever (1) hits companion seat when shifting transfer case to high range, lengthen
adjusting rod (7). Remove tunnel cover (9) from cab floor (8). Back off jamnut (2) from yoke (4).
Remove cotter pin (5) and clevis pin (3) from yoke (4) and relay lever (6). Turn yoke (4) counter-
clockwise to lengthen adjusting rod (7). Install adjusting rod (7) on relay lever (6) with clevis pin (3)
and cotter pin (5). Check for correct free travel of transfer control lever (1) in high and low range.
If travel is correct, tighten jamnut (2) against yoke (4) and lock cotter pin (5).
5.
FOLLOW-ON TASK Install cab tunnels (para. 11-30).
6-6
