TM 9-2320-260-20
I
6-4. TRANSFER CASE SHIFT LEVER AND CONTROL LINKAGE MAINTENANCE (Contd)
Position shaft (7) in bracket (3) and install retainer (2) on bracket (3) with screw (4) and new
7.
locknut (l). Turn shaft (7) as necessary to engage vertical slot of shaft (7) with retainer (2).
Install bracket (3) and shaft (7) on frame crossmember (26) with two screws (27) and new
8.
locknuts (5). Ensure free end of shaft (7) points to left side of vehicle.
Install transfer control lever (6), short end down, on left end of shaft (7) with washer (8) and new
9.
cotter pin (9). Lock cotter pin (9).
Loosen jamnut (13) on adjusting rod (11) and set clevis holes 8.75 in. (22.3 cm) apart. Do not tighten
10.
jamnut (13).
Install adiusting rod (11) on relay lever (20) and lower hole on transfer control lever (6) with two
11.
clevis pin; (10) ;nd new cotter pins (12). Lock cotter pins (12) at transfer control lever (6). Do not
lock cotter pin (12) at relay lever (20) until adjustments in task c. are completed.
6-5
