LO 9-2350-247-12
LUBRICATION ORDER
(Supersedes LO 9-2350-247-12, March 1982)
8 JULY 1994
KEY
EXPECTED
REFILL
TEMPERATURES*
CAPACITY
INTERVALS
+40F
0F
(APPROX)
Above
to
to
32F
-10F
-65F
OE/HDO (MIL-L-2104C) LUBRICATING OIL
S - 150 Hours,
OE/
OE/
OEA
OR OEA (MIL-L-46167) lNTERNAL COMBUSTION
1,500 Miles
HDO-10 HDO-10
1/4 pt.
ENGINE
or Semi-annually
Winch Transfer
Gearcase
C/MR - Upon
LUBRICATING OIL
CW-11 (VV-L-751)
As Required
CW-11B CW-11A
GOS
CHAIN-WIRE ROPE,
During
EXPOSED GEAR
Maintenance
LUBRICATING OIL
GO (MIL-L-2105)
Repair
GEAR, MULTIPURPOSE
0.75 pt.
GO-
GO-
GO-75
Winch End Frame
80/90
80/90
2.75 pt.
Winch Gear Box
GAA (MIL-G-10924)
GREASE, AUTOMOTIVE
As Required
AND ARTILLERY
All Temperatures
Winch Drive Shaft
For Arctic Operation Refer to FM 9-207
NOTES
threads, and install plug. To fill, remove fill and level plugs
WARNING
and add oil (OE/HDO) until oil level reaches bottom of
Dry cleaning solvent PD-680 is toxic and flam-
level plug hole (refill capacity 1/4 pint). Clean plugs, apply
mable. Death or injury may result. Always use in
a coat of sealing compound* to plug threads, and install
an open area with good air flow, away from sparks,
plugs. During oil change, unscrew gearcase breather
heat, or flames. Wear protective goggles and
and clean with dry cleaning solvent (PD-680, type Ill).
gloves. Do not breathe vapors. Avoid contact with
Apply a light coat of sealing compound* to breather
skin, eyes, and clothes. If you get dizzy while using
threads and install breather.
solvent, breathe fresh air and get medical help. If
solvent gets on hands, wash them. If solvent gets
2. WINCH END FRAME (M548A1/M1015A1). Service
in eyes, flush eyes with fresh water and get medi-
only when contaminated or during maintenance repair.
cal help immediately. Keep fire extinguisher
Drain and refill winch end frame. To drain, remove plug in
nearby.
bottom of end frame. Inspect plug and oil for metallic
particles. If found, notify your supervisor. Clean plug,
1. WINCH TRANSFER GEARCASE (M548A1/
apply a coat of sealing compound* to plug threads, and
M1015A1). Every 1,500 miles or semi-annually, drain
install plug. To fill, remove fill and level plugs, and add
and refill winch transfer gearcase. To drain, remove drain
gear lubricant (GO) until lubricant reaches bottom of level
pIug in bottom of gearcase housing. Inspect plug and oil
plug hole (refill capacity 3/4 pint). Clean plugs, apply a
for metallic particles. If found, notify your supervisor.
coat of sealing compound* to plug threads, and install
Clean plug, apply a coat of sealing compound* to plug
threads.
Use sealing compound - 8030-00-543-4384 antiseize compound - 8030-00-286-5453, or Permatex - 5330-00-252-3391.
Card 35 of 40
