TM 9-2320-392-10-1
SNATCH BLOCK INSTALLATION/REMOVAL
INITIAL SETUP:
Maintenance Level
References
Operator
FM 20-22
WP 0103 00
GENERAL
This work package provides the data and procedures for Installing The Winch Block On
The 30K Winch Cable and Removing The Snatch Block From The 30K Winch Cable On The
M1089A1 Wrecker.
INSTALL SNATCH BLOCK ON 30K WINCH CABLE
1.
Remove snatch block (1) from tool box.
2.
Remove clevis pin (2) from screw (3).
3.
Loosen screw (3) in snatch block (1).
4.
Move plate (4) to side to open snatch block (1).
5.
Place cable (5) in snatch block (1).
6.
Close plate (4) and align holes.
7.
Tighten screw (3) in snatch block (1).
8.
Install clevis pin (2) in screw (3).
CAUTION
Do not exceed a 30-ton pull on snatch block. Failure to comply may result in
damage to equipment.
9.
Attach snatch block (1) to disabled vehicle (FM 20-22).
0073 00-1
