TM 9-2320-366-20-5
NOTE
Perform steps (57) through (60) if a new
digitization power cable is being
installed.
Perform steps (57) and (58) if replacing
the digitization power cable on vehicle
serial numbers 00001 through 11347
equipped with WTEC II controller.
(57) Remove terminal lug TL22 ring terminal (90) from
NEW digitization power cable and strip insulation
5/16 in (8 mm).
(58) Install terminal lug TL22 spade terminal (91) on
NEW
digitization power cable.
NOTE
Perform steps (59) and (60) if replaicng the
digitization power cable on vehicle serial
numbers 00001 through 11347 equipped with
WTEC III controller.
(59) Remove terminal lug TL22, ring terminal (90) from
NEW digitization power cable and strip insulation
5/16 in (8 mm).
(60) Install terminal lug TL22, spade terminal (91) on
NEW digitization power cable and wire 146.
Change 2
20-511
