TM 9-2320-366-20-5
20-54. 200 AMP TERMINAL BLOCK TO POWER DISTRIBUTION PANEL (PDP) 12 VDC
CABLE REPLACEMENT (CONT)
b. Installation.
NOTE
Install plastic cable ties as required.
(1) Route 200 amp terminal block to PDP 12 vdc cable (1)
through bottom of cab (2).
(2) Position 200 amp terminal block to PDP 12 vdc cable (1)
in clamp (3).
(3) Install clamps (3 and 4) on frame rail (5) with screw (6)
and self-locking nut (7).
(4) Position 200 amp terminal block to PDP 12 vdc cable (1)
in clamp (8).
(5) Position clamp (8) on frame rail (5) with screw (9), and
self-locking nut (10).
(6) Tighten self-locking nut (10) to 84-108 lb-in. (10-12 Nm).
(7) Tighten two screws (11) in heat shield assembly (12).
20-302