TM 9-2320-366-20-5
CAUTION
Alternator pulley must be positioned in a vise
equipped with vise jaw caps when loosening
self-locking nut. Failure to comply may result
in damage to equipment.
(99) Position pulley (160) in vise.
(100) Loosen self-locking nut (161).
(101) Remove pulley (160) from vise.
(102) Remove self-locking nut (161), washer (162), and pulley
(160) from alternator (141). Discard self-locking nut.
(103) Position washer (162) and self-locking nut (161) on
(104) Position three clamps (116) on 12vdc cable (163) and
24vdc cable (164).
(105) Position three clamps (116) on air inlet manifold (117)
with three washers (115) and screws (114).
(106) Tighten three screws (114) to 22-27 lb-ft (31-37 Nm).
(107) Position 12vdc cable (163) and 24 vdc cable (164) on
vehicle.
20-260