TM 9-2320-366-20-5
(22) Remove screw (37) and lockwasher (38) from bracket
(29). Discard lockwasher.
(23) Remove self-locking nut (39), screw (40), and bracket
(29) from spare tire retainer (35). Discard self-locking
nut.
(24) Position screw (40) and self-locking nut (39) in spare tire
retainer (35).
(25) Tighten self-locking nut (39) to 43-51 lb-ft (58-69 Nm).
(26) Position lockwasher (38) and screw (37) in front lifting
beam (41).
(27) Tighten screw (37) to 43-51 lb-ft (58-69 Nm).
NOTE
Perform steps (28) through (56) on all models
except M1093/M1094.
Remove plastic cable ties as required.
(28) Lift dust boot (6) on terminal lug TL173 (7).
(29) Remove nut (8), lockwasher (9), and terminal lug TL173
(7) from reverse polarity relay 12V BAT terminal (10).
Discard lockwasher.
(30) Lift dust boot (11) on terminal lug TL174 (12).
(31) Remove nut (13), lockwasher (14), and terminal lug
TL174 (12) from reverse polarity relay 12V LOAD
terminal (15). Discard lockwasher.
(32) Position lockwashers (9 and 14) and nuts (8 and 13) on
reverse polarity relay 12V BAT terminal (10) and 12V
LOAD terminal (15).
20-250