TM 9-2320-366-20-5
17-18. M1089 30K WINCH CABLE REPLACEMENT/REPAIR (CONT)
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and glove; use
only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe the
vapors. Keep away from heat or flame. Never smoke when using solvent; the flash point for Type I
dry cleaning solvent is 100 (38 C) and for Type II is 130 (50 C). Failure to comply may result in
serious injury or death to personnel.
If personnel becomes dizzy while using dry cleaning solvent, immediately get fresh air and medical
help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes,
immediately flush eyes with water and get immediate medical attention. Failure to comply may
result in injury to personnel.
(6) Clean cable end thoroughly.
(7) Position spelter socket (4) on fanned area of cable
(1) until contact is made with top edge of wrapped
wire (2).
WARNING
Adhesive
sealant
can
damage your eyes.
Wear safety
goggles/glasses when using; avoid
contact with eyes. If sealant contacts
eyes, flush eyes with water and get
immediate medical attention. Failure to
comply may result in injury to personnel.
CAUTION
Allow sealing compound to cure before
adding resin. Failure to comply may result in
damage to equipment.
(8) Apply 1 in (25mm) wide bead of sealant between
bottom of spelter socket (4) and wrapped wire (2)
(9) Position cable (1) and spelter socket (4) vertically in
vise.
17-78.2
Change 2
