TM 9-2320-366-20-5
c. Inspection.
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and
gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do
not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the
flashpoint for Type I Dry Cleaning Solvent is 100F (38C) and for Type II is 130F (50C).
Failure to comply may result in serious injury or death to personnel.
If personnel become dizzy while using Dry Cleaning Solvent, immediately get fresh air and
medical help. If Dry Cleaning Solvent contacts skin or clothes, flush with cold water. If Dry
Cleaning Solvent contacts eyes, immediately flush eyes with water and get immediate
medical attention. Failure to comply may result in injury to personnel.
(1) Clean all metal parts with dry cleaning solvent.
NOTE
Replace any part that fails visual inspection.
(2) Inspect swivel hook (1), latch (2), and spring (3) for
cracks, pitting, and corrosion.
(3) Inspect lanyard (4) for frayed wires and corrosion.
(4) Check safety pin (5) for tight fit in latch (2).
d. Assembly.
(1) Install latch (1) on swivel hook (2) with spring (3),
lanyard (4), screw (5), and self-locking nut (6).
(2) Install safety pin (7) in latch (1).
17-9