TM 9-2320-366-20-4
This task covers:
a. Removal
d. Installation
b. Disassembly
e. Follow-On Maintenance
c. Assembly
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Spare tire removed (TM 9-2320-366-10-2).
Gloves, Rubber (Item 13, Appendix C)
Cab raised (TM 9-2320-366-10-1).
Goggles, Industrial (Item 15, Appendix C)
Cab leveling valve removed (para 16-8).
Socket Set, Socket Wrench (Item 36, Appendix C)
Air/hydraulic power unit and bracket removed
Wrench, Torque, 0-200 lb-in. (Item 59, Appendix C)
(para 19-3).
Ether starting aid removed (para 4-15).
Materials/Parts
Shunt removed (para 7-29).
Dispenser, Pressure Sensitive Adhesive Tape (Item 20,
100 amp reverse polarity relay removed, if
equipped (para 7-30).
Cap and Plug Set (Item 14, Appendix D)
200 amp reverse polarity relay removed, if
Ties, Cable, Plastic (Item 69, Appendix D)
equipped (M1094) (para 20-47).
Nut, Self-Locking (8) (Item 167, Appendix G)
Nut, Self-Locking (12) (Item 156, Appendix G)
Nut, Self-Locking (Item 128, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Pin, Cotter (2) (Item 231, Appendix G)
Wrench, Torque, 0-175 lb-ft (Item 58,
Personnel Required
Pan, Drain (Item 24, Appendix C)
(3)
a. Removal.
(1) Remove four self-locking nuts (1), eight washers (2), and
four screws (3) from spare tire retainer (4). Discard self-
locking nuts.
(2) Remove four self-locking nuts (5), eight washers (6), and
four screws (7) from spare tire retainer (4). Discard self-
locking nuts.
