TM 9-2320-366-20-4
This task covers:
a. Reading Diagnostic Codes
d. Exiting the Diagnostic Display Mode
b. Clearing Active Diagnostic Codes
e. Follow-On Maintenance
c. Clearing Historic Diagnostic Codes
INITIAL SETUP
Equipment Conditions
Master power switch positioned to on (TM 9-2320-366-10-1).
a. Reading Diagnostic Codes.
NOTE
Diagnostic codes may be viewed even while
vehicle is moving.
There are two types of diagnostic codes, active
and historic, which may be displayed on WTEC
II TEPSS. An active diagnostic code indicates a
fault which is currently being detected by WTEC
II TEPSS. An historic diagnostic code represents
a fault which was detected prior to engine
shutdown. All active diagnostic codes, except
main code 69 sub code 34, will become historic
codes when electrical power is removed from
WTEC II TEPSS.
When an active diagnostic code is displayed on
WTEC II TEPSS, the MODE ON light will be
illuminated.
(1) Enter diagnostic display mode by pressing ↑ (1) and ↓
(2) (up arrow and down arrow) buttons on WTEC II
TEPSS (3) at the same time.
