TM 9-2320-366-20-4
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Materials/Parts
Batteries disconnected (para 7-57).
Ties, Cable, Plastic (Item 69, Appendix D)
Nut, Self-Locking (2) (Item 128, Appendix G)
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
Remove plastic cable ties as required.
(1) Disconnect connector J52 (1) from connector P52R (2).
(2) Remove two self-locking nuts (3), screws (4), washers
(5), and rear intervehicular 12 vdc (7 pin) cable (6) from
vehicle. Discard self-locking nuts.
Change 1
