TM 9-2320-366-20-4
(14) Install PDP (15) in dashboard (12) with three screws
(16).
(15) Install three washers (17) and screws (18) in PDP (15).
(16) Position grille (19) on cab (2) with washer (20) and
screw (21).
(17) Position two washers (22) and screws (23) in grille (19).
(18) Tighten screw (21) to 48-60 lb-in. (5-7 Nm).
(19) Tighten two screws (23) to 24 lb-in. (3 Nm).
(20) Install rear lights cable assembly (1) in clamp (24).
NOTE
Other terminal lugs may be installed with
clamp and rear lights cable assembly.
(21) Position two terminal lugs TL101 (25), TL83 (26), and
clamp (24) on right frame rail ground stud (27) with self-
locking nut (28).
(22) Tighten self-locking nut (28) to 84-108 lb-in. (10-12 Nm).
Change 1
7-411
