TM 9-2320-272-24-4
Slide cylinder head (17) over piston rod (18) and position on cylinder housing (19).
5.
Install cylinder head (17) on cylinder housing (19) with ten new lockwashers (12) and screws (13).
6.
Tighten screws (13) 8-10 lb-ft (11-14 N-m).
Install packing (16) around piston rod (18) in cylinder head (17). Use fingers to position new
7.
packing (16).
Slide gland (15) over piston rod (18) until seated against packing (16) and install on cylinder head (17)
8.
with three screws (14).
Install orifice plug (2) and orifice plug cover (1) in cylinder base (3).
9.
NOTE
Short bypass tube connector block is located in middle of cylinder.
Install two bypass check balls (7), springs (6), and plugs (5) in short bypass tube connector
10.
block (4).
NOTE
Long bypass tube connector block is located at head end of
cylinder.
Install one bypass check ball (10), spring (9), and plug (8) in long bypass tube connector block (11).
11.
Position hinge pin (21) in cylinder base (3) until aligned with holes for screws (20) and install two
12.
square-head screws (20).
5-622
