TM 9-2320-272-24-4
5-93. BLACKOUT BYPASS WIRING HARNESS MAINTENANCE
THIS TASK COVERS:
a. Removal
c. Installation
b. Repair
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M934/A1/A2
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
l Parking brake set (TM 9-2320-272-10).
l Battery ground cabled disconnected (para. 3-126)
a. Removal
NOTE
Tag wires for installation
1.
Remove six screws (1) and cover (2) from load center (6).
2.
Remove two setscrews (10) and wires (3) from 3-pole circuit breaker (5).
3.
Remove screw (8) and wire (9) from 30 amp circuit breaker (7).
4.
Remove two screws (13) and cover (14) from switch (11).
5.
Remove two screws (12) and switch (11) from van body (16).
6.
Loosen three screws (15) and remove wires (3) from switch (11).
7.
Remove wiring harness (4) from van body (16).
b. Repair
For wiring harness repair, refer to para. 3-131.
c. Installation
1.
Position wiring harness (4) on van body (16).
2.
Install three wires (3) on switch (11) and tighten three screws (15).
3.
Install switch (11) on van body (16) with two screws (12).
4.
Install cover (14) on switch (11) with two screws (13).
5.
Install wire (9) on 30 amp circuit breaker (7) with screw (8).
6.
Install two wires (3) on 3-pole circuit breaker (5) with two setscrews (10).
7.
Install cover (2) on load center (6) with six screws (1).
5-580
