TM 9-2320-272-24-4
36.
Apply adhesive sealant to setscrew (24).
Install new seal (23) on retaining collar (25) with large lip toward baffle (7).
37.
38.
Install retaining collar (25) on recess of main input shaft (6) with setscrew (24). Tighten
setscrew (24) 12-16 lb-ft (16-22 Nm).
39.
Apply a light coating of gasket sealant to mating surfaces of oil pump (26) and transfer case (15).
NOTE
Ensure to align pump drive with slot on main input shaft.
Install oil pump (26) on transfer case (15) with six washers (18) and screws (17). Tighten
40.
screws (17) 40-65 lb-ft (54-88 N-m).
41.
Apply a light coating of gasket sealant to mating surfaces of speedometer drive cover (22) and
transfer case (15).
Install speedometer drive cover (32) on transfer case (15) with six washers (21), four screws (20),
42.
and two screws (19). Tighten screws (19) and (20) 40-65 lb-ft (54-88) Nm).
Install new seal (28) and slinger (27) on flange (29).
43.
Apply gasket sealant to new hi-lo shift shaft seal (30) and install on transfer case (15).
44.
5-417
