TM 9-2320-272-24-4
5-46. TRANSMISSION OIL PUMP AND FRONT SUPPORT MAINTENANCE (Contd)
NOTE
Perform step 15 only if needle bearing was previously removed.
15.
Position needle bearing (8) on converter ground sleeve (9). Ensure numbered end of needle
bearing (8) faces outward.
16.
Using bearing installer and driver handle, press needle bearing (8) into converter ground
sleeve (9) 1.240-1.260 in. (31.50-32.00 mm) below outer edge of bore.
NOTE
Perform steps 17 and 18 only if converter pressure regulator valve
was previously removed.
17.
Place valve spring (11) and converter pressure valve (10) on new valve guide pin (7).
18.
Press new valve guide pin (7) into front support (1) until new value guide pin (7) extends
1.16-1.20 in. (29.46-30.48 mm) above finished surface.
NOTE
Two seal rings for front support hub are installed when oil pump
and front support are installed in transmission.
5-319
