TM 9-2320-272-24-4
5-45. TRANSMISSION MANUAL SELECTOR SHAFT REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP:
EQUIPMENT CONDITION
APPLICABLE MODELS
Transmission selector shaft oil seal removed
All
(para. 4-76).
TOOLS
Transmission control valve removed (para. 5-44).
General mechanic's tool kit (Appendix E, Item 1)
SPECIAL ENVIRONMENTAL CONDITIONS
Torque wrench (Appendix E, Item 146)
Work area clean and free from blowing dirt and
REFERENCES (TM)
dust.
TM 9-2320-272-24P
1.
Remove shaft retainer pin (3) from transmission housing (4).
2.
Remove nut (2) and detent lever (1) from transmission manual selector shaft (5).
3.
Remove transmission manual selector shaft (5) from transmission housing (4).
1.
Tilt transmission housing (4) to horizontal position with the bottom facing upward.
2.
Install manual selector shaft (5) and detent lever (1) on transmission housing (4) with nut (2).
Tighten nut 15-20 lb-ft (20-27 Nm).
3.
Secure manual selector shaft (5) in transmission housing (4) with shaft retainer pin (3).
5-308
