TM 9-2320-272-24-4
5-34. R.Q.V. GOVERNOR COVER MAINTENANCE (Contd)
d. Assembly
1.
Install spring (12)and rocker arm (13) in governor cover (3).
2.
Install intermediate plates (14) and (16) and linkage lever (15) in governor cover (3).
3.
Install shaft (11) in governor cover (3).
4.
Install shim (10), template (9), and shim (8) on governor cover (3) with new lockwasher (7) and
screw (6).
5.
Install two new drive pins (17) in linkage lever (15) and shaft (11).
e. Adjustment
1.
Position control lever (4) in full load position so pilot (5) contacts bottom end of template slot (1).
Position new gasket (2) on governor cover (3).
2.
3.
Place straightedge on governor cover (3). Using depth gauge, measure from straightedge to pilot (5).
Distance should be 0.098 in. (2.49 mm).
NOTE
Perform steps 4 through 7 if measurement is incorrect.
Remove screw (6), lockwasher (7), shim (8), template (9), and shim (10) from governor cover (3).
4.
5.
If distance is less than 0.098 in. (2.49 mm), use smaller shim (10).
6.
If distance is more than 0.098 in. (2.49 mm), use larger shim (10).
7.
Install shim (10), template (9), and shim (8) on governor cover (3) with lockwasher (7) and screw (6).
f. Installation
NOTE
Safety wire will not be installed at this time. Safety wire will be
installed after fuel pump is calibrated (para. 5-37).
Linkage lever piston must fit into cylinder on lever located in
governor housing.
1.
Install new gasket (2) and governor cover (3) on governor housing (18) with five screws (24) and
screw (21).
Install governor stop (19) on governor cover (3) with two spacers (20), new lockwashers (25), and
2.
screws (26).
NOTE
Apply sealing compound to male threads.
Install new gasket (23) and guide pin (22) in governor cover (3).
3.
5-230
