TM 9-2320-272-24-4
5-33. MANIFOLD PRESSURE COMPENSATOR MAINTENANCE (Contd)
NOTE
Apply silicone adhesive to mating surfaces of pull-stop cover and
manifold pressure compensator.
4.
Install pull-stop cover (28) on manifold pressure compensator (1) with three new lockwashers (29)
and screws (30).
5.
Install new lockwasher (18) and new breakoff screw (17) on pull-stop cover (28).
6.
Install nuts (31) and (32) on stop bolt (7).
7.
Install new O-ring (16) on pull-stop (15).
8.
Place pull-stop (15) in pull-stop cover (28).
9.
Install protective cap (33) on pull-stop cover (28) with new lockwashers (14) and (34), screw (13),
and new breakoff screw (35).
10.
Install plug (24) on governor housing (23).
NOTE
Safety wire will not be installed at this time. Safety wire will be
installed after fuel pump is calibrated (para. 5-37).
FOLLOW-ON TASK: Calibrate fuel injection pump (para. 5-37).
5-227
