TM 9-2320-272-24-2
4.
Apply a small amount of GAA grease to rounded edge of new woodruff key (17) and install on
cross shaft (11). Grease will hold woodruff key (17) in place.
5.
Insert cross shaft (11) into cross shaft lever (2) and install with screw (1) and new locknut (3).
NOTE
Assistant will help with step 6 through 8.
6.
Install rubber seal (27) and ring seal (28) on cab floor (26) with six screws (30) and new locknuts (25).
7.
Position cross shaft (11), cross shaft lever (2), and cross shaft retaining clamps (6) on cab floor (26).
8.
Install two shims (7) and cross shaft retaining clamps (6) on cab floor (26) with four screws (5) and
new locknuts (18).
9.
Install brake lock control valve rod (24) on cross shaft lever (2) with washer (31) and new cotter pin (29).
10.
Install PTO cable swivel bolt (22) on cross shaft lever (2) with new locknut (21).
Install shim (10) and PTO control cable (23) on bracket (9) with clamp (20), two screws (8), and new
11.
locknuts (19).
Install driver's seat (para. 3-283).
FOLLOW-ON TASKS:
Check transfer case PTO for proper operation (TM 9-2320-272-10).
4-957
