TM 9-2320-272-24-3
THIS TASK COVERS:
a.
Removal
c. Assembly
b.
Disassembly
d. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M936/A1/A2
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
EQUIMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
Parking brake set (TM 9-2320-272-10).
MATERIALS/PARTS
Eight locknuts (Appendix D, Item 285)
Two cotter pins (Appendix D, Item 76)
NOTE
Front and rear roller braces are maintained the same way.
Remove four locknuts (9), screws (2), and two front roller braces (4) from boom (1). Discard locknuts (9).
1.
Remove
two cotter pins (3) from shaft (7). Discard cotter pins (3).
2.
Remove
shaft (7) and level wind roller (6) from two roller braces (4).
3.
Remove
shaft (7) from roller (6).
4.
Remove
two bearings (5) from roller (6).
5.
Remove
grease fitting (8) from shaft (7).
1.
Install
two bearings (5) in roller (6).
2.
Install
grease fitting (8) in shaft (7).
3.
Install
shaft (7) in roller (6).
4.
Install
two braces (4) on shaft (7) with two new cotter pins (3).
Install two roller braces (4) on boom (1) with four screws (2) and new locknuts (9).
4-906
