TM 9-2320-272-24-3
THIS TASK COVERS:
a. Disassembly
c.
Assembly
b. Cleaning and Inspection
INITIAL SETUP:
APPLICABLE MODELS
MATERIALS/PARTS (Contd)
M936/A1/A2
Eighteen lockwashers (Appendix D, Item 393)
Gasket (Appendix D, Item 218)
TOOLS
Six lockwashers (Appendix D, Item 392)
General mechanic's tool kit (Appendix E, Item 1)
Two bushings (Appendix D, Item 25)
Puller (Appendix E, Item 110)
Two woodruff keys (Appendix D, Item 737)
Arbor press
GAA grease (Appendix C, Item 28)
Feeler gauge
Lubricating oil (Appendix C, Item 50)
Mandrel
Rags (Appendix C, Item 58)
Sealing compound (Appendix C, Item 65)
TEST EQUIPMENT
PERSONNEL REQUIRED
Spring tester (Appendix E, Item 132)
Dial indicator (Appendix E, Item 36)
Two
Micrometer (Appendix E, Item 80)
REFERENCES (TM)
MATERIALS/PARTS
LO 9-2320-272-12
Brake band (Appendix D, Item 15)
TM 9-2320-272-10
Four cotter pins (Appendix D, Item 57)
TM 9-2320-272-24P
Two gaskets (Appendix D, Item 217)
EQUIPMENT CONDITION
Two seals (Appendix D, Item 610)
O-ring (Appendix D, Item 459)
Rear winch removed (para. 3-332).
Bushing (Appendix D, Item 26)
Rear winch level wind removed (para. 4-174).
Gasket (Appendix D, Item 216)
GENERAL SAFETY INSTRUCTIONS
Seal (Appendix D, Item 609)
Seal (Appendix D, Item 611)
The rear winch is a heavy component. Use hoist
Five lockwashers (Appendix D, 350)
during repair to prevent injury.
1.
Remove four cotter pins (10), pin (91, pin (11), and lever (7) from bracket (8). Discard cotter pins (10).
2.
Remove four screws (16) and lockwashers (17) from bracket (15). Discard lockwashers (17).
3.
Remove two screws (18), nuts (20), lockwashers (19), and bracket (15) from tensioner frame (14).
Discard lockwashers (19).
4.
Remove two nuts (l), lockwashers (2), screws (6), and tensioner frame (14) from bracket (8). Discard
lockwashers (2).
5.
Remove two nuts (4), lockwashers (5), four screws (13), four washers (12), and bracket (8) from rear
winch (3). Discard lockwashers (5).
4-864
