TM 9-2320-272-24-3
4-95. TRANSFER CASE (M936/A1/A2) REPLACEMENT (Contd)
Remove two screws (8), washers (9), and PTO cable bracket (10) from transfer case (12).
4.
Remove locknut (16) and parking brake cable (4) from parking brake lever (17). Discard locknut (16).
5.
Remove two locknuts (14), screws (2), clamp (3), parking brake cable (4), and spacer (1) from
6.
parking brake cable bracket (15). Discard locknuts (14).
Disconnect speedometer driveshaft (11) from speedometer drive adapter (13).
7.
Remove screw (6), washer (5), clamp (7), and speedometer drive cable (11) from transfer case (12).
8.
Remove eight locknuts (20), screws (19), and propeller shaft (21) from transfer case front output
9.
flange (18). Discard locknuts (20).
Remove two screws (26), washers (27), and parking brake cable bracket (25) from transfer case
10.
cover (28).
Remove screw (24), clamp (23) with parking brake cable (4), and clamp (22) with speedometer drive
11.
cable (11) from transfer case (12).
NOTE
Tag all air lines and wires for installation.
Disconnect supply line (33) from air cylinder elbow (32).
12.
Disconnect supply line (39) from interlock air cylinder elbow (29) and interlock valve elbow (38).
13.
Disconnect supply line (31) from interlock valve elbow (30).
14.
Disconnect interlock vent line (37) from elbows (36) and (40).
15.
Disconnect two vent lines (42) from elbows (41).
16.
Disconnect interlock valve lead (35) from connector (34).
17.
Remove locknut (45), washer (44), transorb diode ground wire (46), locknut (47), ground wire (48),
18.
lockwasher (49), cable clamp (50), and screw (43) from frame (51). Discard locknuts (45) and (47)
and lockwasher (49).
4-538
