TM 9-2320-272-24-2
NOTE
Wrap male pipe threads with antiseize tape before installation.
Install intake manifold (3) and three new gaskets (5) on cylinder heads (1) with eight screw-
1.
assembled washers (4). Tighten screw-assembled washers (4) 25-30 lb-ft (34-41 Nm).
NOTE
Perform step 2 only if clamps were removed previously.
Install two clamps (27) and fuel tubes (29) on intake manifold (3) with screw (28). Tighten screw (28)
2.
20-25 lb-ft (27-34 Nm).
Install cable ground strap (17) on intake manifold (3) with washer (14), new lockwasher (15), and
3.
screw (16). Tighten screw (16) 25-30 lb-ft (34-41 Nm).
Install wire harness (23) and clamp (22) on lower left side of air intake connector (2) with
4.
screw (21). Tighten screw (21) 25-30 lb-ft (34-41 Nm).
Install elbow (19) and air cleaner indicator filter (20) on left side of air intake connector (2).
5.
Connect hose (18) to elbow (19).
6.
Connect air tube (6) and nut (12) to adapter (13) on air governor (11).
7.
Connect air tube (6) and nut (25) to elbow (24) on air compressor (26).
8.
Position two clamps (7) to screw hole in top left of engine access cover (10) and install air tube (6)
9.
and two clamps (7) on air intake connector (2) with washer (8) and screw (9). Tighten screw (9)
25-30 lb-ft (34-41 Nm).
4-182