TM 9-2320-272-24-2
WARNING
All personnel must stand clear during lifting operations. A
snapped cable, or swinging or shifting load, may cause death or
injury to personnel.
1.
Install utility chains and lifting device on two lifting brackets (1).
2.
Remove six bolts (3) and engine block (2) from engine stand.
WARNING
Ensure engine weight is evenly distributed. Failure to do so may
result in injury or death to personnel.
3.
Lower engine block (2) from engine stand.
4.
Install bracket (15) on engine block (2) with screw (14).
5.
Install bracket (15) on air compressor (17) with washer (13) and screw (12).
6.
Install air inlet line (8) on air compressor (17) and fitting (4) with screw (9) and tighten clamps (5).
NOTE
Wrap male threads of elbow with antiseize tape.
7.
Install elbow (10) on engine block (2).
8.
Install air compressor oil line (16) on elbow (10) and tighten nut (11).
9.
Apply antiseize tape to threads of oil pressure sending unit (6) and install on engine block (2).
10.
Apply antiseize tape to threads of oil sampling valve (7) and install on engine block (2).
NOTE
Ensure all matting surfaces are clean before installing new
gaskets.
11.
Install new gasket (18) and power steering pump (19) on air compressor (17) with two washers (21)
and screws (20).
12.
Install new gasket (30) and fuel transfer pump (28) on engine block (2) with two screws (29).
13.
Install fuel supply tube (27) on engine block (2) with two new washers (22) and screw (23).
14.
Install fuel return manifold (24) and new banjo seal (26) on screw (23) with screw (25).
4-108