TM 9-2320-272-24-2
3-433. CONVOY WARNING LIGHT HARNESS REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
REFERENCES (TM)
APPLICABLE MODELS
TM 9-2320-272-10
All (except M929/A1/A2, M930/A1/A2,
TM 9-2320-272-24P
M934/A1/A2)
EQUIPMENT CONDITION
TOOLS
Parking brake set (TM 9-2320-272-10).
General mechanic's tool kit (Appendix E, Item 1)
Hood raised and secured (TM 9-2320-272-10).
MATERIALS/PARTS
Battery ground cables disconnected (para. 3-126).
Locknut (Appendix D. Item 288)
Lockwasher (Appendix D, Item 405)
Fifteen tiedown straps (Appendix D, Item 687)
Six tiedown straps (Appendix D, Item 685)
NOTE
Perform steps 1 and 2 for left and right rear of cab.
1.
Disconnect four cable leads (6) from harness (7).
2.
Remove locknut (5), ground lead (4), washer (3), lockwasher (2), and screw (10) from frame (11) and
rear step hanger (9). Discard locknut (5) and lockwasher (2).
3.
Remove six tiedown straps (1) and harness (7) from cab crossmember (8). Discard tiedown straps (1).
NOTE
Note routing of harness lead for installation.
4.
Remove fifteen tiedown straps (17) and harness lead (15) from front main wiring harness (16).
Discard tiedown straps (17).
5.
Remove screw (14), clip (13), and harness lead (15) from relay (12).
1.
Install harness lead (15) on relay (12) with clip (13) and screw (14) .
NOTE
Perform steps 2 and 3 for left and right rear of cab.
2.
Install screw (10), new lockwasher (2), washer (3), ground lead (4), and new locknut (5) on rear step
hanger (9) and frame (11).
3.
Connect four cable leads (6) to harness (7).
NOTE
Tiedown straps must be installed 10 in. (25 cm) apart.
4.
Install harness (7) on cab crossmember (8) with six new tiedown straps (1).
5.
Install harness lead (15) on front main wiring harness (16) with fifteen new tiedown straps (17).
3-1114