TM 9-2320-272-24-2
3-327. FRONT WINCH CABLE REPLACEMENT
THIS TASK COVERS:
b. Installation
a Removal
INITIAL SETUP:
APPLICABLE MODELS
EQUIPMENT CONDITION
l Parking brake set (TM 9-2320-272-10).
All with winch
l Front winch cable unwound (TM 9-2320-272-10).
TOOLS
General mechanic' tool kit (Appendix E, Item 1)
s
GENERAL SAFETY INSTRUCTIONS
REFERENCES (TM)
Wear hand protection when handling winch cable.
TM 9-2320-272-10
TM 9-2320-272-24P
WARNING
Wear hand protection when handling winch cable. Broken wires
may cause injury to personnel.
a. Removal
Remove setscrew (1) and winch cable (4) from hole (3) in winch drum (2).
1.
NOTE
Perform step 2 if front winch is equipped with level wind and
tensioner.
Pull winch cable (4) out at side roller (9), over level wind pulley (6), down through tensioner
2.
sheaves (7), and out of rollers (8) and (9).
b. Installation
NOTE
Perform step 1 if front winch is equipped with level wind and
tensioner.
Thread winch cable (4) into center of rollers (8) and (9), tensioner sheaves (7), under level wind
1.
pulley plate (5), and over level wind pulley (6).
Insert winch cable (4) in hole (3) of winch drum (2) and install setscrew (1).
2.
3-834