TM 9-2320-272-24-2
3-328. FRONT WINCH MOTOR REPLACEMENT (Contd)
b. Installation
NOTE
l If new winch motor is being installed, transfer fittings from old
winch motor. Fittings must be clean and free of defects.
Wrap all male threads with antiseize tape before installation.
l
Align winch motor shaft key (3) with keyway of winch gear shaft (1) and install new gasket (2) and
1.
winch motor (6) on winch motor adapter (7) with four new lockwashers (5) and screws (4).
Connect hydraulic return hose (9) and supply hose (10) to elbows (8) on winch motor (6).
2.
Lower front of winch (11) and align holes of left and right support plates (16) with holes of frame
3.
rails (21) and support plate brackets (20).
Install six washers (14), new lockwashers (13), and screws (12) on left and right support plates (16)
4.
and frame rails (21). Finger tighten screws (12).
Install six washers (18), screws (17), and new locknuts (19) on left and right support plates (16) and
5.
support plate brackets (20).
Tighten screws (12), (15), and (17).
6.
Remove lifting device and chain from front winch (11).
7.
3-838
