TM 9-2320-272-24-2
3-226. STEERING WHEEL REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
REFERENCES (TM)
APPLICABLE MODELS
All
TM 9-2320-272-10
EQUIPMENT CONDITION
TOOLS
Parking brake set (TM 9-2320-272-10).
General mechanic's tool kit (Appendix E, Item 1)
Wheels straight (TM 9-2320-272-10).
Torque wrench (Appendix E, Item 144)
Horn switch removed (para. 3-104).
Puller (Appendix E, Item 110)
1.
Loosen clamp (6) and slide turn signal control (8) down steering column (7).
NOTE
Perform step 2 only if vehicle is equipped with hand airbrake
control lever.
2.
Loosen two screws (5) and slide hand airbrake control lever (4) down steering column (7).
3.
Loosen nut (2) until flush with top of steering wheel shaft (3).
4.
Install two adapters (14) and (13) on steering column (7) and steering wheel shaft (3).
5.
Install puller on adapters (14) and (13) and tighten puller screw until steering wheel (1) is loose.
6.
Remove puller, nut (2), two adapters (14) and (13), and steering wheel (1) from steering column (7).
NOTE
Perform steps 7 and 8 on vehicles equipped with turn signal
canceling ring.
7.
Remove spring (12) from steering wheel shaft (3).
8.
Remove three screws (11), turn signal canceling ring 10), and steering wheel ring (9) from steering
wheel (1).
3-651