TM 9-2320-272-24-1
3-176. PARKING BRAKESHOES REPLACEMENT
THIS TASK COVERS:
b. Installation
a. Removal
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
TM 9-2320-272-10
All
TM 9-2320-272-24P
SPECIAL TOOLS
EQUIPMENT CONDITION
Brake repair pliers (Appendix E, Item 20)
Wheels chocked (TM 9-2320-272-10).
TOOLS
Transfer case-to-forward rear axle propeller shaft.
General mechanic's tool kit (Appendix E, Item 1)
removed (para. 3-150 or 3-151).
Torque wrench (Appendix E, Item 144)
NOTE
Parking brakeshoes should be replaced when parking brake lever
full travel is over 2.0 in. (5.1 cm).
1.
Remove thrust nut (6) and washer (5) from transfer output shaft (1).
2.
Remove parking brakedrum (3) and transfer output shaft flange (4) from transfer output shaft (1).
3.
Remove transfer output shaft flange (4) from parking brakedrum (3).
4.
Remove eight studs (2) from parking brakedrum (3).
5.
Using brake repair pliers, remove two brakeshoe return springs (8) from parking brakeshoes (9).
6.
Remove two parking brakeshoes (9) and actuating plate (10) from brakeshoe backing plate (7).
3-490
