TM 9-2320-272-24-1
3-150. TRANSFER CASE TO FORWARD-REAR AXLE PROPELLER SHAFT MAINTENANCE
(Contd)
NOTE
Perform steps 8 through 12 only for vehicles equipped with old
propeller shaft.
8.
Install dustcover (5), spacer (6), center bearing mounting bracket (10), spacer (23), dustcover (22),
and center bearing companion flange (20) on forward propeller shaft (4) with nut (19). Tighten
nut (19) 100-115 lb-ft (136-156 N.m). If needed, turn nut (19) clockwise to align nearest slot with
hole in shaft (4) to install new cotter pin (18).
9.
Install new cotter pin (18) on nut (19) and forward propeller shaft (4).
NOTE
Assistant will help with steps 10 through 14.
10.
Install center bearing mounting bracket (10) on crossmember (9) with four screws (8) and new
locknuts (7).
NOTE
Position rear-rear propeller shaft so that grease fitting on U-joint
faces downward. Refer to new configuration for steps 13 and 14.
11.
Install rear propeller shaft (15) companion flange (16) on center bearing companion flange (20) with
eight screws (17) and new locknuts (21). Tighten locknuts (21) 30-40 lb-ft (41-54 N.m).
12.
Install spacer (6) and dustcover (5) on forward propeller shaft front section (4).
13.
Install forward propeller shaft front section (4) on forward propeller shaft aft section (24).
14.
Install rear propeller shaft yoke flange (14) on forward-rear axle yoke flange (11) with eight
screws (13) and new locknuts (12).
15.
Install transfer case shaft yoke flange (2) on transfer case brake drum (1) with eight new locknuts (3).
3-418