TM 9-2320-272-24-1
3-150. TRANSFER CASE TO FORWARD-REAR AXLE PROPELLER SHAFT MAINTENANCE
(Contd)
NOTE
Perform steps 10 through 14 for M927A2, M928A2, M934A2, and
M935A2 models only.
Remove eight locknuts (9), screws (7), and rear axle flange (8) from center bearing flange (6).
10.
Discard locknuts (9).
Remove eight locknuts (13) and flange (14) from transfer case brakedrum studs (1). Discard
11.
locknuts (13).
Remove two locknuts (12), screws (4), washers (3), center bearing (11), forward-rear axle propeller
12.
shaft (10), and vibration damper (5) from bracket (2). Discard locknuts (12).
Remove locknut (15), washer (16), clamp (17), spacer (18), screw (20), and clamp (19) from bracket (2)
13.
and crossmember (22). Discard locknut (15).
Remove three locknuts (24), washers (23), screws (21), and bracket (2) from crossmember (22). Discard
14.
locknuts (24).
Straighten tabs on two universal plates (26).
15.
Remove four screws (25), two universal plates (26), bearing caps (34), and universal joint (28) from
16.
center bearing propeller shaft (27). Discard universal plates (26).
b. Disassembly
NOTE
Perform disassembly for M927A2, M928A2, M934A2, and M935A2
models only.
1.
Loosen dust seal (31) on shaft (30).
2.
Remove shaft (30) from shaft (32).
3.
Remove dust seal (31) from shaft (32).
4.
Remove grease fitting (33) from yoke (29).
c. Cleaning and Inspection
WARNING
Drycleaning solvent is flammable and toxic. Do not use near open
flame and always have fire extinguisher nearby when solvents are
used. Use only in well-ventilated places, wear protective clothing,
and dispose of cleaning rags in approved container. Failure to do
this may result in injury or death to personnel and/or damage to
equipment.
1.
Clean all parts in drycleaning solvent and allow to dry.
2.
Inspect all parts for cracks, fitting, or scoring. Replace parts as necessary if cracked, pitted, or
scored.
3-414
