TM 9-2320-272-24-1
THIS TASK COVERS:
a. Light Assembly Removal
c. Lamp Removal
b. Light Assembly Installation
d. Lamp Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-272-10
TM 9-2320-272-24P
TOOLS
EQUIPMENT CONDITION
General mechanic's tool kit (Appendix E, Item 1)
Parking brake set (TM 9-2326-272-10).
MATERIALS/PARTS
Battery ground cables disconnected (para. 3-126).
Two lockwashers (Appendix D. Item 351)
Remove four screws (7) from warning light panel (1) and pull warning light panel (1) away from
1.
instrument panel (2).
Remove lamp lens (10) from lamp holder (5).
2.
Remove two screws (9) and lockwashers (8) from warning light panel assembly (1) and lamp holder
3.
bracket (6). Discard lockwashers (8).
NOTE
Tag wire for installation.
Disconnect wire (3) from lamp holder connector (4).
4.
Remove lamp holder (5) and bracket (6) from warning light panel assembly (1).
5.
Install lamp holder (5) and bracket (6) on warning light panel assembly (1) with two new
1.
lockwashers (8) and screws (9).
Connect wire (3) to lamp holder connector (4).
2.
Install lamp lens (10) on lamp holder (5).
3.
Install warning light panel (1) on instrument panel (2) with four screws (7).
4.
NOTE
All panel light lamps are removed and installed the same.
Remove lamp lens (10) from lamp holder (5).
1.
Push lamp (11) inward and turn counterclockwise to remove.
2.
Push lamp (11) inward and turn clockwise to install.
1.
Install lamp lens (10) on lamp holder (5).
2.
3-246
